Printable Projects

This Will work with the E3Dv5 hot end and maybe others of the same length i do not think the E3Dv6 will work as it is shorter and i made this have really tight clearances as not to lose Z as it is

Using the new 123D Catch for android i was able to do my first 3d "scan" of this piggy

The Stand for the Saber Tooth was not printing well and kinda sucked so i took the nice T-Rex one and modified it to the Saber Tooth. My printer threw a pulley when printing it the first time.

The thingi post with proper remix notes

It has been said that if this where to be printed it may rip open a wormhole and suck in the earth destroying existence as we know it. These 3 precariously placed squares measure 20mm 50mm and 100mm at 5mm tall with 2mm walls that makes the inner sizes 16mm 46mm and 96mm

I could not find any sand molds so i made some they may be a little big for the kinetic sand

Remixed from http://www.thingiverse.com/thing:37282

I made this to hold a bunch of plastic forks.

Printed on an mm2 with full support

I could not find a dish that was made to be put in the corner of a cage so i made this

I took the Minion for Minion Army by Doodle_Monkey and made it so i could print in dual color. i did this a few months ago and have not gotten around to testing it until now. I have repaired the files so they are more friendly and uploaded them. I also added a pic of the minion i printed.

This is a Gir figure I printed I did not make it just thought I would use it as the first post Gir is from Invader Zim

This is a standard cube used for calibration.

This is a new take on the calibration cube. I feel it is a good test of X,Y,and Z on top of testing temperature and layer binding..

I made this adapter so i could better run my qu-bd on my MendelMax 2. Along with following the steps in the pics you must flip over your X axis. this allows for the nozzle to reach the print bed.

I found this design but when i printed and mounted it my fan hit my pololus so i made it taller. Print two and bolt on 40mm fan

Modified from thingiverse.com/thing:28735 for cooling a dual QU-BD on a MM2 i have redesigned this to work better

I could not find a printable k-cup holder that worked so i made one. i have yet to print it and will update this once i have.

This is a spool clip for a 90- 96mm wide spool with 1.75mm filament I use it for my Octave Spools. I am reposting it as i accidentally deleted it.